Troubleshooting - Amazon Basics B071VNC8M4 Manual Del Usuario

Cleaning the Motor Filter
• We recommend to clean the Motor filter about twice a
year or when it appears to be dirty.
• The filter is installed behind the air outlet grid. Pull the
tab of the outlet grid and remove it.
• Pull down the tab at the top of the filter and remove it.
• Rinse the filter with warm water.
• Let the filter dry completely. Do not expose it to direct
sunlight.
• Put the filter back in place and reinstall the air outlet grid.
• Both filter and grid must click into place.
NOTICE

Troubleshooting

Problem
The appliance does not start.
Weak suction power.
Motor is abnormally noisy.
Dismantling for Maintenance
1. Hose, extension tube, dust bag, exhaust grid, filter and all accessories can be
disassembled or detached without any tools.
2. Front cover, cable winder, switch, power suction control and on/off button can be
disassembled by using a screwdriver.
3. PCB, power cord and motor compartment could be accessed by removing 7
screws on the main unit (6 screws on the bottom and 1 beneath the handle cover
on right lower lateral).
4. Motor unit can be accessed by loosening the screws on the motor compartment.
12
Never use the appliance without filters installed. This can
cause power loss or damage to the appliance.
Solution
• Connect the power plug properly.
• Check if the electrical outlet is powered.
• Check if the on/off switch is on.
• Check if the flexible hose, expansion tube or
any of the accessories are obstructed.
• Remove and clean the filters.
• Stop using the appliance immediately.
• Check if the hose, tube or any of the
accessories are obstructed.
• Remove the obstruction.
• If the noise continues, power off the appliance
and disconnect the power plug.
• Contact your service agents.
5