How To Operate - Nostalgia Electrics PCM805 Manual De Instrucciones

HOW TO OPERATE

1. First, find a stable surface near an electrical outlet before
starting. Make sure the cord is away from any water source.
It is acceptable to use an extension cord if needed.
2. Plug in unit at the OFF position.
3. Turn unit ON position and allow it to run for at least 3-5 minutes before
adding hard candy. This will allow the Extractor Head to heat.
4. Turn unit OFF and place no more than two pieces of hard candy or one scoop of
flavored sugar (1 tbsp.) into the Extractor Head. Make sure the candies are evenly
placed on either side of the Extractor Head (see image below).
5. Switch to ON position.
6. When you see the cotton candy web begin, collect the cotton
candy on the cone by holding the cone vertically. Rotate the
cone with your fingers while you circle the bowl.
7. Once cotton candy has collected on the cone, hold the cone in a horizontal
position over the Extractor Head while still rotating the cone with your fingers.
Continue turning the cone with your fingers while the cone is in the horizontal
position and move from side to side making sure to collect all the cotton candy.
8. Repeat above steps by adding another measure of candy into
the Extractor Head and starting again. The cotton candy should
flow more quickly as the unit is sufficiently warm.
9. DO NOT overfill the Extractor Head by adding more than two candies
at a time. This will cause clogging and unit will not work properly.
10. By following these simple instructions, using your HARD & SUGAR-
FREE COTTON CANDY MAKER will be a fun experience for kids of all
ages and will bring the excitement of a carnival to any occasion.
6