Alan HP 08 Manual De Instrucciones página 28

10
LOCK (Keypad lock)
11 MSGSET (Message edit)
12 NAME (Channel name displayed)
13 NM SET (Channel name edit)
15 OPNMSG (Welcome message displayed)
16 PSWD (open password)
17 PSWD W (password setting)
18 ROGER (end transmission tone)
19 SCN MD (scan mode)
20 STE(side tone eliminate)
21 TOT (time-out timer)
22
TXSTOP (transmission stop)
23 VOX
24 VOX D (VOX delay)
25 VOX S (VOX sensitivity levels)
26 VXB (busy VOX)
Automatic switch off (APO)
With this function, the unit automatically turns off at a preset time (from 1 to 15
hours from the setting). One minute before the switching off, "APO" blinks on
the display and a warning beep is heard.
To enable/disable the APO feature:
Access menu 1 by pressing F and 9 sel, choose the desired setting with the
▲/▼ and confirm by pressing again 9 sel.
Voice mode (APRO)
From menu 2 you can activate two different voice modes:
› COMP: Compander, it allows to improve the signal/noise ratio.
› SCRAMB: scrambler
(to activate one of these modes, follow the general procedure described in par.
10
'General use of the menu' at page 9).
K+S /PTT/KEY/ALL
Programmable
Channel groups
FREQ/ALPHA
When this function is enabled, the stored channels belong to groups of chan-
Programmable
nels.
BANK: channel group function activated.
OFF/DC/MSG
The channels will be divided into 15 channel groups
ON/OFF
Group
Programmable
ON/OFF BANK1
TO/CO/SE
BANK2
ON/OFF
BANK3
OFF/from 6 sec to 7 min
BANK4
ON/OFF
BANK5
ON/OFF
BANK6
1S, 2S, 3S, 4S
BANK7
1-8
BANK8
ON/OFF
BANK9
BANK10
BANK11
BANK12
BANK12
BANK13
BANK14
BANK15
BANK16
BANK17
BANK18
BANK19
Channels HP108 HP408L
ch1-16 ● ●
ch17-32 ● ●
ch33-48 ● ●
ch49-64 ● ●
ch65-80 ● ●
ch81-96 ● ●
ch97-112 ● ●
ch113-128 ● ●
ch129-144 ● ●
ch145-160 ● ●
ch161-176 ● ●
ch177-192 ● ●
ch177-180
ch193-208 ● ●
ch209-224 ● ●
ch225-240 ● ●
ch240-256 ● ●
ch257-272 ●
ch273-288 ●
ch289-298 ●
HP408H
●
●
●
●
●
●
●
●
●
●
●
●