Warmup Butech 8GM Manual De Operación página 2

8GM
This is an Easy Setup guide. For full instructions please visit
www.butech.net
INTRODUCTION
This thermostat is designed to aid in the comfort of your home by providing timed regulation of
your heating system. The thermostat is designed to receive temperature input signals from the
following sensors:
1. Air sensor located inside thermostat
2. Floor sensor installed in floor if using underfloor heating (see heater instructions for
details)
The thermostat is not a safety device. In order to avoid damaging your system the correct system
and floor type should be selected during the thermostat programming process.
WARNING – Important safety note
This product uses mains voltage electricity and work should only be carried out by a qualified
electrician. You should always isolate the power supply before attempting to install or repair
the thermostat. The thermostat should not be put into operation unless you are certain that
the entire heating installation complies with current general safety requirements for electrical
installations. Electrical installation to be in accordance with latest Wiring Regulations.
LOCATION
The thermostat should be installed inside a single gang electrical wall box that is at least
35mm deep. For optimal performance the thermostat should be located in an area with good
ventilation. It should not be beside a window/door, in direct sunlight or above another heat
generating device (e.g. radiator or TV). The thermostat is designed for operation between
0°C - 40°C with relative humidity less than 80%.
2
Smart Controller