Pairing A Bluetooth Device; Pairing A Bluetooth Device Using Nfc; Using The Radio - ION TAILGATER GO Guia De Inicio Rapido

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Tailgater Go and it will automatically go into pairing mode to search for Bluetooth devices. You will know you
are in pairing mode when the Bluetooth icon is off.
3. Navigate to your Bluetooth device's setup screen, find "Tailgater Go" and connect.
Note: If your Bluetooth device prompts for a pairing code, enter "0000".
4. The Bluetooth icon will be lit solid when a device is "paired" to Tailgater Go.
5. Press the Bluetooth button to disconnect a paired Bluetooth device.
6. To connect to another Bluetooth device, repeat steps 3-4.

Pairing a Bluetooth Device Using NFC

NFC (near-field communication) allows data exchange from devices, such as pairing, by gently bumping them together. Check
in your device's manual to see if this feature is supported.
To use NFC to pair with Tailgater Go:
1. In order to use NFC, your device must be turned on and unlocked.
2. Enter your device's Settings menu and check that NFC is turned On (one time step).
3. Power on Tailgater Go.
4. Touch and briefly hold your device to the NFC logo.
5. Follow the pairing instructions that appear on your phone. If a passcode is required, enter "0000".
6. To unpair, gently bump your device against the NFC logo located on the top panel of Tailgater Go.

Using the Radio

Selecting a Radio Station:
1. Press the Radio button to choose FM/AM.
2. Select a radio station using the –/+ buttons.
Note: If there is poor AM reception, disconnect AC power for optimal AM radio reception. To further adjust AM reception,
move the entire unit.
Saving a preset:
1. Press the Radio button to choose FM/AM and select a radio station that you want to save to a preset location using the
–/+ buttons.
2. Press and hold Play/Pause for 3 seconds. A preset number will appear on the screen.
3. Use the –/+ buttons to select which preset you want to save it to.
4. Press Play/Pause to confirm. SAVE will appear on the screen.
Selecting a preset:
Press Play/Pause to cycle through the saved presets.
Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source, musical instrument, or microphone. Also, try
to reduce the overall volume of Tailgater Go using the Master Volume knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level. This will allow
you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably feedback. Point the microphone away
from the speaker.
If there is poor AM reception: Disconnect AC power for optimal AM radio reception. To further adjust AM reception, move
entire unit.
If you can't hear the microphone over the music volume: Turn down the music volume from your source.
If you can't play music from a flash drive: The USB port is only for charging USB devices.
5