HoMedics NMS-350 Manual De Instrucciones E Información De Garantía página 4

Maintenance
To Store
Place massager in its box or in a safe, dry, cool place. Avoid contact with
sharp edges or pointed objects which might cut or puncture the fabric
surface. To avoid breakage, do not wrap the power cord around the unit.
Do not hang the unit by the hand control cord.
To Clean
Unplug the unit and allow it to cool before cleaning. Spot clean only with
a soft, slightly damp sponge. Never allow water or any other liquids to
come into contact with the unit.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene,
glass / furniture polish or paint thinner to clean.
• Do not attempt to repair the Shiatsu & Vibration Neck
There are no user serviceable parts. For service, send the unit to
the HoMedics address listed in the warranty section.
6
Massager.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
7