Mx Onda MX-PI2612 Manual De Usuario E Instalacion página 62

Simmer
Simmering occurs below the boiling point, around 85 ° C, when bubbles
occasionally rise to the surface of the cooking liquid. It's the key to
delicious tender soups and stews because flavors develop without
overheating the food. You should also cook thickened egg and flour based
sauces below the boiling point.
Some tasks, including cooking rice by the absorption method, may require
a setting higher than lower to ensure that food cooks properly in the
recommended time.
CLEANING THE INDUCTION HOB
Dirt type
Daily soiling on the
glass surface
(fingerprints, marks,
food stains or
unsweetened spills)
Spills from
sugary foods
Dirt and spill stains
on the control panel
How to clean
1. Disconnect the power from the
board using the switch or
differential enabled for this.
2. Use an induction hob cleaner
while the surface is warm (but
not hot!)
3. Rinse and dry the plate with a
clean cloth or paper towel.
4. Reconnect the board to power
Remove them immediately using
a scraper suitable for induction
hobs, but be careful with hot
surfaces in the cooking zone:
1. Disconnect the power from the
board using the switch or
differential enabled for this.
2. Hold the scraper at a 30 °
angle and scrape dirt to a cool
area of the plate.
3. Wipe up dirt or spills with a
kitchen towel or paper towel.
1. Disconnect the power from the
board using the switch or
differential enabled for this.
2. Clean the control panel area
with a clean, damp sponge or
cloth.
3. Completely dry the control
panel area
4. Reconnect the
power.
When turning off the power to
the
indication of a hot surface, but
the cooking zone still be hot!
Use special scouring pads for
induction hobs. Do not use
harsh, corrosive or abrasive
cleaners that can damage the
plate. Always read the label to
see if your cleanser or scourer is
suitable. Never leave residue on
the surface, the glass can stain.
Remove stains from melting and
sugary foods or spills as soon as
possible. If allowed to cool on the
glass, it can be difficult to clean or
even permanently damage the
surface of the hob.
Cut Hazard - When the safety
cover is retracted, the blade on a
scraper becomes sharp. Use it with
great care and always store safely
and out of the reach of children.
Liquid spillage in the area of the
control
induction hob to malfunction, the
touch
properly.
Be sure to thoroughly clean and
dry the control panel area before
reconnecting the board to power.
board to
16
Important
hob, there will
panel may cause
buttons may not
be no
the
work