Descargar Imprimir esta página

Shindaiwa SP41BPS Manual De Uso Y Cuidado página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 7
Figure 8
Protective
Dust Cap
Figure 9
DISASSEMBLING AND REPAIRING THE PUMP ASSEMBLY
1. Release the pressure from the sprayer and remove all liquid from both the pressure chamber and tank.
2. Remove hose.
3. Remove the In-tank filter from the pressure chamber.
4. Remove 2 bolts attaching the pivot lever to the pump shaft and remove piston assembly (fig. 2a & 2b).
5. Remove the large clamp holding the pressure chamber and tank together (fig 1).
6. Rock the pressure chamber back and forth and push down to free it from the tank (fig 1).
7. Once freed the entire pump assembly can be removed by maneuvering it through the base frame
(fig 3a & 3b).
In-Tank
Filter
Figure 1
7) Apply Petroleum jelly to the inside of the piston cylinder wall
and on the collar, and reinstall the piston assembly into the piston
cylinder.
8) Insert the piston at an angle with the leading edge of the
collar placed over the slot in the piston cylinder. Bolt the piston
assembly to the pump shaft using the lever bolts.
9) Replace the protective dust cap. Tighten the
nut and bolt. Reinstall the pump handle. Replace the hose
and firmly secure the hose clamp in place.
Clamp
Figure 2a
Figure 2b
Pressure
Chamber o-ring
Figure 3a
9E
Pump
Assembly
Figure 3b

Publicidad

loading