LIGHT BULBS
1. To replace light bulbs, first disconnect power to the
oven at the circuit breaker panel or by unplugging.
2. To release cover, remove the screw on the light
cover. (See illustration.)
3. Replace light bulbs with equivalent watt bulb
available from your Fulgor Authorized Servicer or
parts distributor. Bulbs are also available at most
hardware stores or lighting centers. DO NOT USE A
BULB LARGER THAN 30 WATTS.
4. Close light cover and secure with screw removed in
step 2.
CAUTION: Light cover may become very hot. Do
not touch glass when light is on.
Light cover
Screw
22
Models MWOR330A2ABL/WH/SS, MWOR330A3ABL/WH/SS
Replacing Parts
Light bulbs
CHARCOAL FILTER
Charcoal Filter, which was installed in your oven, is
used for nonvented, recirculated installation. The filter
should be changed every 6 to 12 months depending on
use.
1. Disconnect power to the oven at the circuit breaker
panel or by unplugging.
2. Remove the three louver mounting screws and
push down carefully on the tab at each end of the
louver to disengage it. (See illustration.)
3. Pull the louver away from the unit.
4. Change the charcoal filter.
5. Carefully push the louver back into place (engag-
ing both the bottom and top tabs) and replace the
screws removed in step 2.
Top tab
Charcoal filter
(white side
faces front)
Screw
Screw
Use & Care Manual
ENGLISH
Louver
Screw
Bottom tab