Chal-tec auna Connect System Manual Del Usuario página 72

EN
72
Fast backward within a track: Long press the  button on the HiFi or on the
remote control.
Stop: Short press the  button on the HiFi or on the remote control.
Programmed play mode
In programmed play mode, you can program the play order of the tracks on
your CD. You can program up to 20 tracks in total.
NOTE:
To set up programmed play mode, the CD must be stopped in the CD
compartment and must not be paused or playing.
In CD mode, with the CD you wish to program in the CD compartment and
stopped ...
1. Short press the Preset button on the HiFi or the Prog. button on the
remote control to enter CD programmed play mode. "PO1 T00" will be
displayed and "00" will flash.
2. Use the  and  buttons on the HiFi or on the remote control to go to
the track number that you would like to program to play first. Short press
the Preset button on the HiFi or the Prog. button on the remote control
to confirm.
3. "P02 TOO" will now be displayed and "00" will flash You can now select
the second track that you would like to program. Continue to select each
track as in Step 2 above, up to a total of 20 tracks. Short press the Preset
button on the HiFi or the Prog. button on the remote control again to
confirm the last track in the programmed play mode list.
NOTE:
If you try to store more than 20 tracks, the CD track programming will begin
again at "P01 T00"
4. Short press the   , button on the HiFi or on the remote control to play
the programmed tracks.
5. To exit programmed play mode, press and release the  button twice
on the HiFi or on the remote control.
Repeat and random modes
Short press the Repeat button on the remote control.
Continuously press and release the Repeat button to cycle through the
available options of:
• Repeat current track
• Repeat all (all the tracks on the CD)
• Random (random play order)
is displayed.
is displayed.
is displayed.
is displayed.