Putting Into Operation - CLAS OH 9030 Manual De Instrucciones

OH 9030
The body, handle and other parts of the jack are packed in a
three-layer corrugated cardboard box with pallet.
- The instruction "Keep upright" is clearly visible on the cardboard
box containing the jack.
- Either transpallets or forklift-trucks are used for handling.

PUTTING INTO OPERATION

ASSEMBLY
1. Take the handle, the jack and the extensions out of the cardboard
box.
2. Loosen the two nuts from inside the chassis. DWG. 9
3. Loosen wheels screws from the chassis and remove parts keeping
them assembled.
4. Fit the handle (the air distributor must be facing the pistons) inserting
the coupling in the groove, put the parts removed previously into the
hole of the handle, tighten and then tighten nut.
5. Connect the two air pipes between the jack and the handle with
the quick couplings on the chassis respecting the colour indication as
showed on the sticker on the chassis itself. DWG.10
CONNECTION TO THE COMPRESSED AIR SYSTEM
- Compressed air enters into the jack circuit through the quick coupling
on the top of the manual lifting/descending controls; it is therefore
necessary to have a connecting pipe with a quick coupling compatible
with that of the jack.
Check that the air supply pipe has a useful passage of at least 6 mm
and it is not pinched or restricted anywhere. DWG. 11
Working air pressure: 8 - 12 bar
- Absolutely never put the following into the compressed air circuit:
hydraulic or Vaseline oil, brake liquid, kerosene or other liquids.
HIGH LIFT AIR HYDRAULIC JACK 30T
PACKING