Controls & Features - Southland SELS60 Manual Del Operador

Specifications
• Save all instructions
Unit Weight ............................................105 lbs (48 kg)
Ram Force ........................................................... 6 Ton
Cycle Time ................................................. 18 Seconds
Wedge Size .............................. 5 Inch Hardened Steel
Gear Pump ................................................ Singe Stage
Max Log Length......................................... 20.5 Inches
Max Log Diameter ....................................... 10 Inches*
* Maximum Log Diameter is an approximate. Actual maximum log diameter is dependent upon log shape,
consistency, wood type and internal moisture.
Controls & Features
Read, understand and follow this owner's manual
before operating the equipment. Familiarize yourself
with the location and function of the controls and
features. (Fig 1)
Motor Switch - Depress switch to electrically
1.
activate the electric motor. Upon release, the
switch will return to an off position.
Hydraulic Control Lever - Controls the forward
2.
and backward movement of ram.
5 Inch Wedge - Splits and separates the log.
3.
Ram - Pushes the log into the wedge.
4.
Vent Screw - Loosen to prevent buildup of
5.
internal air pressure. Tighten after use and
when moving to prevent leakage.
Hydraulic Pump - Pumps the hydraulic oil
6.
through the system.
Support Leg - Supports the Log Splitter
7.
while operating.
Handles - For moving the Log Splitter.
8.
Oil Drain and Fill Port - For adding or removing
9.
hydraulic fluid.
Reset Button - Detects overload and disables
10.
motor. Push to reset.
Stroke Limiter - Reduces the return stroke for use
11.
with shorter logs.
Pressure Limiting Screw - Factory set. Do NOT
12.
adjust.
Questions? Call Toll Free at 1-800-737-2112
Electrical Requirement ....................... 120V AC - 60Hz
Hydraulic Oil Type ......... Shell Tellus 22, Mobil DTE10,
ARAL Vitam GF 22, BP Energol HLP-HM22
Hydraulic Fluid Max ............... Approximately 3.5 Liters
Max Hydraulic Pressure ................................ 3480 PSI
Ambient Operating Temperatures ...............14° - 100°F
12
2
7
1
9
EN - 6
(-10° to 38°C)
4
3
10
6
Copyright © 2018 MAT Engine Technologies, LLC
11
8
5
Fig 1