CS Unitec MABasic 200 Instrucciones De Manejo página 13

M A B a s i c 2 0 0 a n d 4 0 0
In s e r t t h e c o r e d r i l l i n t o t h e d i r e c t t o o l
m o u n t ( i l l u s t r a t i o n A)
Before mounting, clean the Weldon
‹
shank and direct tool mount (2) of the
machine.
Check the the lead connection for
‹
lubricant.
Unscrew the two Allen screws in the
‹
direct tool mount using the hexagonal
offset screwdriver (25) supplied.
Insert the core drill in the direct tool
‹
mount (2).
NOTE
► Insert the appropriate ejector pin (23)
before inserting the core drill.
Tighten the two Allen screws in
‹
the direct tool mount (2) using the
hexagonal offset screwdriver (25)
supplied.
R e m o v i n g t h e t o o l
Unscrew the two Allen screws in the
‹
tool mount (2) using the hexagonal
offset screwdriver (25) supplied and
remove the core drill from below.
M A B a s i c 2 0 0 , 4 0 0 , 4 5 0 , 8 5 0
M A B a s i c 4 5 0 a n d 8 5 0
In s e r t t h e c o r e d r i l l i n t o t h e i n d u s t r i a l
h o l d e r ( i l l u s t r a t i o n B )
Push the industrial holder (26) into the
‹
spindle taper of the machine.
Before inserting, clean the Weldon
‹
shank of the tool and the tool holder.
Check the the lead connection for
‹
lubricant.
Unscrew both Allen screws in the tool
‹
mount using the hexagonal offset
screwdriver (25) supplied.
Insert the core drill into the tool mount.
‹
NOTE
► Insert the appropriate ejector pin (23)
before inserting the core drill.
Tighten both Allen screws in the tool
‹
mount (2) using the hexagonal offset
screwdriver (25) supplied.
R e m o v i n g t h e t o o l
Unscrew the two Allen screws in the
‹
tool mount (2) using the hexagonal
offset screwdriver (25) supplied and
remove the core drill from below.
P r e p a r a t i o n
1 5