T R O U B L E S H O O T I N G - CS Unitec MABasic 200 Instrucciones De Manejo

F a u l t
The motor does not start after
pressing the ON/OFF switch
or stops during operation.
The automatic circuit breaker
in the electrical distribution
board trips.
The magnetic clamp does not
function.
The lubrication system does
not function.
NOTE
► If you cannot resolve the problem with the steps described above, please contact
customer service.
M A B a s i c 2 0 0 , 4 0 0 , 4 5 0 , 8 5 0

T r o u b l e s h o o t i n g

Po s s i b l e c a u s e
Plug not inserted into socket.
Automatic circuit breaker
tripped.
The magnetic clamp is not
switched on.
Too many appliances con-
nected to the same power
circuit.
The machine is defective.
Magnet not switched on.
The surface is not magnetic.
No lubricant available.
Lubricant tap closed.
Connecting nipple clogged.
T r o u b l e s h o o t i n g
R e m e d y
Insert plug.
Switch on the automatic circuit
breaker again.
Switch on the magnetic clamp.
Reduce the number of appli-
ances on the power circuit.
Contact customer service.
Switch on the magnet.
Use a suitable base.
Top up the lubricant.
Open the lubricant tap.
Clean the tank and nipple.
1 9