Toshiba MMY-MAP0501HT8-E Manual Del Propieratio página 21

u High Wall Type
(Model : 1H series)
• Push the projection at the center of air filter. Clip is out.
• Undo the clip of air filter, pull the air filter downward while pushing it
toward the main unit side.
(Model : 2H, 3H series)
• Open the air inlet grille. Lift the air inlet grille up to the horizontal position.
• Take hold of the left and right handles of the air filter and lift it up slightly, then pull downward to take it out
from the filter holder.
2H series
Return the air filter
• Insert the upper portion of air filter confirming to fit it is right and left
edges on the indoor unit until it is firmly set.
• Close the air inlet grille.
Cleaning the air inlet grille
1. Remove the air inlet grille.
Hold the two sides of the air inlet grille and open upwards.
Move the center arm to the left and remove the grille.
2. Wash it with water using a soft sponge or towel.
(Do not use metallic scrubbing brush or other hard brushes.)
• Use of such hard objects will cause scratches on the surface of the
grille, and the metal coating to peel off.
• If very dirty, clean the air inlet grille with a neutral detergent for
kitchen use, and rinse it off with water.
3. Wipe out water from the air inlet grille and dry it.
4. Fit the left and right arms of the air inlet grille to the shafts on the two
sides of the air conditioner and push in completely, and then push in
the center arm.
5. Check that the center arm has been completely inserted and close the
air inlet grille.
• Push the arrow locations (Four) at the bottom of the air inlet grille to
check whether the grill is completely closed.
3H series
Filter holder
20
Push the air filter,
and pull it downward.
Filter holder
English-20