Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRACTICEBEFOREUSE
Wesuggest t hatyoupractice withyourmuterbefore
installing a cutterandmaking cutsinwood.Check
the followingbeforeconnectingyour routerto a
powersupply.
•
Make sure power supply is 120 volts, 60 Hz, AC
only.
•
Make sure there is not a cutter in the collet.
•
Make sure collet does not extend below the subbase.
•
Plug muter into power supply.
•
Grasp muter firmly with both hands and turn on.
HANDLE
HELPFUL
HINTS
,/
Always clamp workpiece securely before routing.
•/
A safe operator is one who thinks ahead.
J
Always wear eye protection when routing.
J
Make setup adjustments carefully. Then double
check. Measure twice and cut once.
J
Keep cutters clean and properly sharpened.
J
Don't let familiarity make you careless.
J
Study all safety rules and do the job safely.
J
Never place your hands in jeopardy.
,/
Make certain clamps can't loosen while in use.
J
Test difficult setups on scrap -- Don't waste
lumber.
,/
Plan each operation before you begin.
J"
Provide for smoother operation by cleaning your
,_2
router frequently. Shake router or blow with an air
jet to remove sawdust buildup.
•/
Think safety by thinking ahead.
,"1_
STARTING/STOPPING
ROUTER
•
Grasp handles using both hands. See Figure 9.
•
To start muter: Press the switch to the I position. See
Figure 10.
•
To stop router: Press the switchto the O position.
See Figure 10.
POWER
HANDLE
(O)TOSTOP
Fig. 9
( I ) TO START
SWITCH
Fig. 10
12
Publicidad
Tabla de contenido
