Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
SWITCH
See Figure 19.
•
Unplug your router.
WARNING:
Failure to unplug your router could
result in accidental starting causing serious
injury.
•
Remove screws and handle cover.
•
Note the location of the molded bend relief on the
power handle cord. Also note all wiring in the
handle and how each lead is connected to the
switch. Connections and wiring position must be
identical when installing new switch.
•
Remove switch from leads by unplugging the flag
terminals as shown.
•
Make lead connections to new switch. Push each
flag terminal as far as possible into proper switch
receptacle. Pull on leads to check lead connections
with lead receptacles.
•
Locate switch in handle and place leads back into
wire traps, as originally assembled, so they will not
be pinched or contact screws when handle cover is
replaced.
•
Make sure molded bend relief is correctly
positioned in switch handle, then replace handle
cover and screws.
•
Tighten all screws securely.
BENDRELIEF
SWITCH
HANDLECOVER
SCREWS
BLACKLEAD
Fig. 19
19
Publicidad
Tabla de contenido
