Kichler 12217 Manual Del Usario página 5

OPERATION
LANDSCAPE LOW VOLTAGE TRANSFORMER Model# 12217
**READ FIRST**
Press the MENU button repeatedly for the green light to rotate around the digital
display until the desired function to be programmed is lit and then press the
ENTER button.
Always then press the ENTER button after each setting to lock in your selection
and to finish programming.
While programming, if ENTER is not pressed within 30 seconds, the transformer
will select the current setting (after 10 seconds in TEST mode).
To scroll through the clock settings more quickly, press and hold down the UP
and DOWN arrows.
Once programming is finished the display will turn blank, it will NOT continue to
show the current time.
In the event of a power outage the transformer functions may need to be reset.
Setting the clock to local time
(Must be completed before any other programming):
a) Press MENU until the Green CLOCK LED indicator is lit and the digital display
is flashing, then press ENTER.
b) When AM and PM begins to flash, press the UP or DOWN arrow button to
select AM or PM and press ENTER.
c) When the hour begins to flash, press the UP or DOWN arrow to desired hour
and press ENTER.
d) When the minute begins to flash, press the UP or DOWN arrow to desired
minute and press ENTER.
The clock setting is now complete.
The Green Clock Light and the current time with AM/PM will remain lit for a minute
before the display goes blank.
IMPORTANT GENERAL PROGRAMMING NOTES:
5