Maintenance Recommendations; Troubleshooting Tips & Warranty - Kasco LE275 Manual Del Proprietário

2. Arrange the brackets into the position shown, then
tighten down the nuts. Once the brackets are secure,
turn the unit back into its upright position.
Make sure 2 holes are
aligned before tightening
3/8" nuts down
3. Follow the instructions on the previous page for
installation of the lights onto the lower fl oat brackets
except use the 1/4" x 2" bolts (part #4) that came with
the adapter kit instead of the bolts that came with the
light kit, and use the round spacers (part #3) between
the light fi xture bracket and the lower fl oat bracket.

Maintenance Recommendations

** Under No Circumstances should anyone enter the
water while a fountain is operating.
** Please keep the original box for maintenance shipping.
The following maintenance procedures can be utilized to
ensure many years of quality performance from your Kasco
Fountain and Light Kit and reduce the need for more costly
repair work.
PROPER INSTALLATION: Proper installation of Kasco
equipment will include a power source with (RCD) ground
fault interruption. RCD Ground fault interrupters are a
safety feature that can also alert you to electrical leaks in
the equipment. If you have repeat, consistent trips on your
RCD ground fault, the equipment should be disconnected
and removed from the water. The power cord should be
inspected for damage and you should call your Kasco
Marine distributor for further instructions or email Kasco at
service@kascomarine.com.
OBSERVATION: Operating equipment should be observed
on a regular basis (daily, if possible) for any reduction
or variation in performance. If a change in performance
is observed, the equipment should be disconnected from
power and inspected.
WINTER STORAGE: In regions where there is signifi cant
freezing in the wintertime, the fountain and light kit should
be removed from the water to protect them from the
expansion pressure of the ice. In many areas, fountains
will keep some amount of ice open through the winter.
However, when the water is thrust into the air, it is exposed
to the colder air temperatures longer and can actually make
ice thicker on the pond/lake. Storage over winter is best in
a location that is out of the sun and cool, but above 0
is not necessary to store Kasco motors upside down. All
internal seals are fully lubricated while stored in an upright
position.
CLEANING: Fountains and light kits should be removed
from the water at least once per year (at the end of the
season in cold climates) to clean the exterior of the system,
especially the stainless steel motor housing (can) and light
fi xtures. The motor housing and bronze light fi xture is the
surface that dissipates heat into the water and any algae,
calcium, etc. build-up will become an insulator that blocks
heat transfer. In warmer regions it is recommended that the
motor is removed and cleaned at least two to three times
per year depending on conditions. In most cases a power
washer will be suffi cient if the unit and algae are still wet.
Also make sure the lenses of the light fi xtures are clean to
ensure the brightest light possible.
Repair services should be performed by
or a Kasco trained Authorized Repair Center. Please
contact your Kasco Marine, Inc. distributor or
representative for your nearest Authorized Repair
Center.
Troubleshooting Tips & Warranty
For more tips and information contact your Kasco
distributor or go to
www.kascomarine.com (Under the technical tab)
O
C. It
Kasco Marine
7