Changing Volume Lock - Universal Electronics Cox Guía Del Usario

Cox Manual - final - 082103.qxd

CHANGING VOLUME LOCK

The Cox Universal Remote Control is set to control volume
of a device through your TV while in the TV, VCR, or Cable
mode. However, in the Auxiliary mode, you will still have
separate control of of your auxiliary device' s volume.
If your TV is not remote controllable, or if you would like
the volume to be controlled by a different device, you can
change the Volume Lock setting to control a volume
through a non-associated mode (for example, through the
cable in the TV mode).
To change Volume Lock to CABLE mode:
1. On the remote control, press CABLE once.
Then press and hold SETUP until the
CABLE key blinks twice, then release SETUP.
2. Enter 9 - 9 - 3. The CABLE key will blink twice.
3. Press CABLE once. It will blink twice.
4. Now, whenever you press VOL+, VOL–, or
MUTE, volume will be controlled by your
Cable Converter.
To change Volume Lock to TV mode:
1. On the remote control, press TV once.
Then press and hold SETUP until the TV key
blinks twice, then release SETUP.
2. Enter 9 - 9 - 3. The TV key will blink twice.
3. Press TV once. It will blink twice.
4. Now, whenever you press VOL+, VOL–, or
MUTE, volume will be controlled by your TV.
To change Volume Lock to VCR mode:
1. On the remote control, press VCR once.
Then press and hold SETUP until the VCR key
blinks twice, then release SETUP.
8/21/03 1:31 PM
17
Page 17