Programming Tv/Vcr Combo Control - Universal Electronics Cox Guía Del Usario

AUX
AUX Device ____________________
VCR
TV
CABLE

PROGRAMMING TV/VCR COMBO CONTROL

If you own a TV/VCR Combo, perform the following
instructions to control this device:
1. Turn on your TV/VCR Combo and insert a
video cassette.
On the remote control, press VCR once.
2.
Press and hold SETUP until the VCR key
blinks twice, then release SETUP.
3. Use the setup codes for TV/VCR combos on
page 47 to locate the brand name and then enter
the first four-digit code for your TV/VCR
Combo. If you perform this procedure correctly,
the VCR key will blink twice.
NOTE: If the VCR key did not blink twice after
entering the code's last digit, then repeat steps 2
through 3 and try entering the same code again.
4. Aim the remote control at your TV/VCR
Combo and press POWER once. The device
should turn off. If it does not respond, repeat
steps 2-3, trying each code listed for your brand
until you find one that works. If it still does not
work, try searching for the code (see Searching
For Your Code on page 11).
5. If you've located a TV/VCR setup code that
works your TV/VCR Combo and a separate
TV code is also listed, you'll need to program
this code into the remote control to access
volume control (see Programming Device
Control on page 8).