McCulloch MC1245 Guia Del Usuario página 9

4. Press the Steam Level Selector to control the level of steam low (I),
medium (II) or high (III) (See figure 2, B). Steam can be used without
rotary action.
5. Direct Steam Outlet Tip (or attachment) towards surface you desire to
steam, and press Steam Trigger.
NOTE: Test an isolated area of the surface before use. Pressing
the Steam Trigger activates the unit's pump, the unit will make
a pumping sound. It will take another second or two to begin
producing steam. This also means that the unit will continue to
produce steam for another second or two after Steam Trigger is released.
6. To sanitize, point Steam Outlet Tip, press Steam Trigger and hold approximately 1/2 inch from
surface for at least 5 seconds. This will insure that you have killed germs and bacteria.
CAUTION: Always be sure that Steam Outlet Tip and any attachments are pointed in a
safe direction (away from yourself, other people, pets, and plants) before pressing the
Steam Trigger.
NOTE: Use care when steaming on surfaces that may be warped or damaged by heat
and moisture. Use on these types of surfaces must be limited.
7. Keep Steam Trigger depressed for a continuous flow of steam.
NOTE: During use, you may notice a slight drop in steam pressure, which is normal due
to thermostat cycles. If this happens, release Steam Trigger for 10-15 seconds.
8. Once steaming tasks are complete, immediately unplug grounded power cord from electrical
outlet. To store, follow steps under Proper Storage procedure on Page 10 of this manual.
INSTALLING WATER TREATMENT CARTRIDGE
1. Water Treatment Cartridge is located on the bottom of the Water Tank.
The
NOTE: The Water Treatment Cartridge must be installed for the
Rotary Action Steam Cleaner to function.
2. Insert Water Treatment Cartridge into the unit. Line up the two holes
on the Water Treatment Cartridge (A) with the corre-
sponding posts on the Rotary Action Steam Cleaner (B).
Insert Cartridge until it snaps into place.
NOTE: Many factors affect the frequency in which
the Water Treatment Cartridge will need to be replaced - including amount of use and
water hardness. For heavy use, we recommend replacing it approximately every 2
months. For lighter use, replace every 3-4 months. The Water Treatment Cartridge will
need to be replaced earlier if you notice reduced steam output.
Using Your Rotary Action
Steam Cleaner
B
FIGURE 2
A
ENGLISH | 9
B