Troubleshooting - Albrecht Tectalk Float Manual Del Usuario

If require to listen to weak signal with background noise temporarily,
press and hold MONITOR button for about 2 seconds. You will hear
background noise and possible weak signal from the unit. Release
MONITOR button within 2 seconds to return.
Automatic Power Save
The radio has an Automatic Power Save circuit designed to extend
battery life. If it senses no signal within 10 seconds, it automatically
switches to the Power Save mode. The Power Save icon will appear on
the LC Display.
The radio can still receive transmission in this mode.

Troubleshooting

No power.
Check battery. Ensure that the battery is installed properly.
The battery may be weak. Charge the supplied battery.
Reception is weak.
Press the VOL UP button to increase Volume.
The receiving signal may be weak and/or out of range. If this happens,
press the MONITOR button.
Cannot Change Channels
To change channels, press the MENU button until the channel
number flashes on the LC Display. Press the CH UP or DOWN
buttons to change channels. Battery may be weak. Keypad Lock
must be deactivated.
Range is limited.
The battery may be weak.
Charge the battery if the Battery Level indicator is low. The maximum
range will vary depending on terrain and environment.
Open fields provide the maximum range, while steel/ concrete
structures, heavy foliage and use in buildings and in vehicles may limit
the range significantly.
Wearing the radio close to the body, such as in a pocket or on a belt,
will decrease range; change the location of the radio.
English 29