Denon Professional AUDIO COMMANDER Guia Del Usuario página 5

23
15. Next Track: Press this button to go to the next audio track from a Bluetooth, USB, or SD
card source.
Note: When listening to Bluetooth sources, pressing this button may go to another
playlist or music genre in some apps.
16. Previous Track: Press this button to go to the previous audio track from a Bluetooth,
22
USB, or SD card source.
Note: When listening to Bluetooth sources, pressing this button may go to another
playlist or music genre in some apps.
17. Play/Pause: Press this button to play/pause an audio track from a Bluetooth, USB, or
1
SD card source.
18. Reverb: Adjust this knob to control the amount of reverb applied to the wired and
wireless mic channels.
19. Aux In 1 Volume: Adjust this knob to control the volume for the Aux 1 input.
2
20. Aux In 2 Volume: Adjust this knob to control the volume for the Aux 2 input.
21. 3-Band EQ: Adjust these knobs to control the treble, mid-range, and bass frequencies
for the input signal.
3
22. NFC (near-field communication): Touch and briefly hold your supported and enabled
device to the NFC logo to pair the device.
23. Wireless Antennas: Adjust the antennas to get the best wireless mic reception.
Rear Panel
1
2
1. Aux Input 1: Connect a line-level device, such as a CD player, laptop, smartphone, or
media device, to this 1/8" (3.5 mm) input.
2. Aux Input 2: Connect a line-level device, such as a CD player, tablet, smartphone, or
media device to these coaxial inputs.
3. USB Ports: Both USB ports are capable of 2.1A charging. The top USB port also supports
USB flash drive playback of MP3 and WMA files.
4. SD Card Slot: Connect a SD card here to play your MP3 and WMA files.
5. XLR+1/4": Connect dynamic microphones to these mic inputs.
6. Mic/Line Switch: Press this switch in to have the gain set for mic level sources. Have the
switch in the outward position for line-level sources.
7. Line Output: Connect this 1/4" TRS (6.35 mm) output to another Audio Commander.
8. Wireless Receivers: Select the wireless mic channel using the Up/Down buttons and
press the Set button to link the channel to the wireless mic. See
Microphone Setup
9. Power Input: Connect the included power cable here.
10. Power Switch: Adjust this switch to power Audio Commander on/off.
4
7
8
5
9
6
11 12
3
4
8
for more details.
15
16
10
17
13
14
1
5
6
23
18
19
20
7
10 10
9
Operation > Wireless
21
5