Using Your Hand Mixer - Impecca courant CHM-1550 Manual De Usuario

USING YOUR HAND MIXER

WARNING: Do not plug the Power Cord into an electrical outlet until the Beaters have
been securely attached.
1. Attach the Beaters: Locate the two half circles near the end of each Beater. Also
locate the breaks in the Slots in the Motor Housing. Insert the Beaters into the Slots
such that the half circles go into the breaks. Push down until the Beaters click into
place.
2. Slide the Speed Switch all the way down so "OFF" is visible. This is the off position.
Plug the Power Cord into a standard 120-volt AC electrical outlet.
3. Place the Beaters into the ingredients to be mixed.
4. Slide the Speed Switch to the desired setting. Speeds range from "1" (lowest) to "5"
(highest).
CAUTION: To prevent the Mixer from overheating, do not operate it for more than five
minutes at a time. Allow four minutes off after five minutes of operation.
NOTE: For best results, begin with the lowest speed setting ("1") and increase to a high-
er speed as necessary.
5. To add ingredients, turn the Mixer off and allow the motor to stop. Lift Beaters out
of the mixture and rest the Mixer on its Heel.
6. When mixing is complete, turn the Mixer off. Make sure the motor has stopped be-
fore lifting the Beaters out of the mixture. Unplug the Power Cord from the electrical
outlet.
WARNING: Always turn the Mixer off and unplug the Power Cord before leaving the
Mixer unattended and when it is not in use.
7. Eject the Beaters by firmly pressing the Eject Button.
CAUTION: Never eject the Beaters while the Mixer is operating.
–6–