Technical Services - Hamilton Beach Summit Serie Manual De Operación

Safety Alert Symbols
The following safety alert symbols are used
throughout this manual to alert you to the safety
hazards described below.
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Cut Hazard
Always place cover on container when
blending.
Do not put hands, spoons, or other
utensils in container when blending.
Failure to follow these instructions can
result in broken bones, cuts, or other
injuries.
Burn Hazard
Always use caution when blending
hot contents.
Failure to follow these instructions can
result in burns.
146
INSTRUCTIONS FOR PROPER DISPOSAL OF THIS PRODUCT PURSUANT TO THE
EUROPEAN UNIONʼS DIRECTIVE ON ELECTRICAL WASTE
Please do not dispose of any electrical equipment as ordinary waste. Help conserve natural resources
and protect the environment: when you have finished using this product, please dispose of it at your
local waste collection or recycling centre in the area reserved for electrical equipment. Contact your local
authority to find the nearest waste collection centre. To remind you to dispose of this product responsibly
and separately from ordinary waste, it is marked with the symbol of a crossed-out trash bin.
Electrical Shock Hazard
Disconnect power before
cleaning blender base.
Failure to follow these
instructions can result in
death or electrical shock.
148

Technical Services

For assistance or replacement parts, call our
Technical Services number:
++866-285-1087
www.commercial.hamiltonbeach.com
Sanitizing
Sanitize using 1 tablespoon (15 ml) of household
bleach per 1 gallon (3.8 liter) of clean, cool water
(60°F/16°C), mixed according to the instructions
on the bleach.
1. Fill container with sanitizing solution, replace
cover and filler cap and run on LOW (1) speed for
2 minutes. Empty container.
2. Wipe exterior with soft cloth dampened with
sanitizing solution.
3. Immerse cover and filler cap in sanitizing solution
for 2 minutes.
4. Place empty container on base and run on HIGH
(2) speed for 2 seconds to remove any moisture
from the cutter assembly.
5. When ready to use, rinse with clean water.
150
152
3