Fuse Check/Replacement - SSS Bearcat 20TD Instrucciones De Uso

ENGLISH

FUSE CHECK/REPLACEMENT

1. Disconnect the battery connector (12).
2. Move aside the recovery water drain hose (16).
3. Remove the battery charger cable (I, Fig. 6) from the cable holder (J).
4. Remove the screws (A) and carefully move aside the panel (B) by disengaging the grommet (K) from its housing on the panel
(B).
5. Check/replace the following fuses:
C) Pad system fuse F1: (40 A)
D) Vacuum system fuse F2: (30 A)
E) Drive system fuse F3: (30 A)
F) Signal circuits fuse F4: (3 A)
G) Pump fuse F6: (3 A)
6. Perform steps 1 to 4 in the reverse order.
20
INSTRUCTIONS FOR USE
F
G
A
A
J
A
I
SSS Bearcat 20TD - 9100001264
A
E
D
K
Figure 6
C
P100120
05/2015