Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - SSS Bearcat 20TD Instrucciones De Uso

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. Contact
TRIPLE S in case of doubts concerning the interpretation of the instructions and for any further information.

TARGET

This Manual is intended for operators and technicians qualified to perform the machine maintenance.
The operators must not perform procedures reserved for qualified technicians. TRIPLE S will not be answerable for damages
coming from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The Instructions for use Manual must be kept near the machine, inside an adequate case, away from liquids and other substances
that can cause damage to it.

IDENTIFICATION DATA

The machine model and serial number are marked on the plate (34).
Product number and year of production are marked on the same plate.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identification data.
MACHINE model
PRODUCT code
MACHINE serial number

OTHER REFERENCE MANUALS

– Electronic Battery Charger Manual, to be considered as integral part of this Manual
Moreover, the following Manuals are available:
– Service Manual (that can be consulted at TRIPLE S Service Centers)
– Spare Parts List (supplied with the machine)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be performed by qualified personnel or by TRIPLE S Service
Centers. Only original spare parts and accessories must be used.
Contact TRIPLE S for service or to order spare parts and accessories, specifying the machine model, product code and serial
number.

CHANGES AND IMPROVEMENTS

TRIPLE S constantly improves its products and reserves the right to make changes and improvements at its discretion without
being obliged to apply such benefits to the machines that were previously sold.
Any change and/or addition of accessories must be approved and performed by TRIPLE S.
2
INSTRUCTIONS FOR USE
SSS Bearcat 20TD - 9100001264
05/2015