Battery Insertion - Brunton NOMAD Manual Del Operador

NOMAD Orientation
Congratulations!
You have purchased a high quality Brunton electronic compass. Even though the
Brunton NOMAD is made rugged and durable to withstand the rigors associated with
TM
outdoor use, care must be taken to assure long life of your instrument. Avoid impacts,
dropping, extreme temperatures and store the NOMAD out of the elements.
NOMAD Orientation
1 --
Orientation provides a short description of important NOMAD parts and display. A
detailed description of its operation is provided throughout the manual.
The buttons perform multiple tasks either by pressing or by holding. When instructed
to "press" a button, press the button for less than 1 second. When instructed to "hold"
a button, press and hold for at least 2 seconds unless instructed otherwise.

1.1 Battery Insertion

1.
Remove battery cover by turning the battery cover counter clockwise.
2. Place one CR2032, 3 Volt Lithium battery in the NOMAD
(Fig. 1).
3. Replace battery cover. NOMAD will begin a reset sequence,
then power on automatically.
IMPORTANT! The NOMAD should be calibrated each time the battery is replaced. If
installing the battery for the first time continue reading, and calibrate the compass when
you reach section 2.1-1 Calibration Setting.
1.2 ON/OFF Button (Fig. 2)
The ON/OFF button turns both NOMAD and backlight
power on and off.
1. Hold ON/OFF button for at least 3 seconds to power
NOMAD on. With NOMAD power on, hold ON/OFF
to power NOMAD off.
2. With NOMAD power on, press ON/OFF to turn back
light on for 30 seconds. Backlight will automatically
power off after 30 seconds of the last button press.
To power backlight off before 30 seconds has
elapsed, press ON/OFF.
Figure 1
ON/OFF
Level
ADV
Figure 2
1
ENT