Nice HSTS2 Instrucciones Y Advertencias De Instalacióna página 5

To browse through the menu and the sub-menus, just touch the screen in cor-
respondence to the desired icon.
Various screen models are available as well as several browsing icons.
Before proceeding, get familiar with the screens and icons by consulting fig-
ures 4 and 5.
Note – Some of the icons in this manual are only visible if the HSTS2 is used as
an interface to control the HSCU2 series alarm control units. The icons associ-
ated with scenarios or command groups are shown below by way of example.
The icons related to scenarios or command groups will be displayed only if
associated during the configuration.
3
"A"
3 3
2
2
1
1
4
4
To use and programme the touch screen keypad, see paragraphs:
Chapter 4 - page 5
Using the touch screen keypad as remote control for automation
units
Chapter 5 - page 12
Using the touch screen keypad to programme and control the
HSCU2 series control units. To programme the alarm system, refer to
the HSCU2 control unit instructions manual.
Chapter 6 - page 36
Using the touch screen keypad as a voice answering machine
3
4
A
D
F
I
Key
A - Title of the screen (not touchable).
B - To update the status bar (I) of the
alarm system.
C - To access the Settings menu of the
touch screen keypad.
D - It displays the time (not touchable).
E - It displays the date (not touchable).
F - To access the macro environment for
the management of the domotic menu.
4
B C
E
H
G
G - To access the macro environment for
the management of the alarm.
H - To access the macro environment
for the management of the voice re-
minders.
I - Status bar (status of the alarm and
the touch screen keypad).
English – 3