Nice HSTS2 Instrucciones Y Advertencias De Instalacióna página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5
Increase
Decrease
Record
Stop
Play
Save
Delete
OK
Item unselected
Item selected
Go back to the
previous menu
Go back to the main
screen
4 – English
Icon key
Delete the last character typed
In the alphabetic keypad, switch from upper case
to lower case and vice versa. In the numeric key-
pad, switch from numbers to special characters
Change the keypad from
alphabetic to numeric
Request status of the alarm system
Arrows to scroll vertically
Settings Menu
SIM
Reminders not read
Battery level
Transponder reader on
New event in the
memory of the alarm control unit
Alarm armed
Alarm disarmed
Zone A armed
Zone B armed
Zone C armed
Zone D armed
Zone E armed
Zone F armed
3.2 - Configuring the parameters of the touch screen keypad
To access the menu of the parameters to be edited, touch the icon
then select the icon of the parameter to be edited.
SCREEN
To adjust the display's brightness level.
Touch the keys
or
touch "OK".
AUTO OFF
To set the auto-off time of the touch screen keypad.
Select the desired time. To confirm, touch "OK".
Note – The item "Never" keeps the touch screen keypad always on. It is
advisable to activate this option only if rechargeable batteries are used,
which are regularly charged; e.g. by using the HSTSA1 accessory.
RECHARGE
To enable the battery recharging function if recharge-
able batteries are used. Caution! – Do not recharge non-rechargeable
batteries. This operation could damage the touch screen keypad.
Select the desired item. To confirm, touch "OK".
LINK
To add or delete the association of the touch screen keypad to
an alarm system control unit (see chapter 5).
VOLUME
To adjust the volume level.
Touch the keys
or
touch "OK".
MOTION To enable the movement sensor to allow the keypad to turn
on by a simple movement. The sensor is not active if the touch screen
keypad has been turned off with the ON/OFF key.
Select the desired item. To confirm, touch "OK".
CLOCK To set the date and time. If the keypad is associated with the
alarm control unit, this icon will not be visible and the date and time set
in the alarm control unit will be displayed (see paragraph 5.7.1).
LANGUAGE
To configure the language of the touch screen.
FIRMW.
To display the firmware version of the touch screen keypad.
to make the adjustment. To confirm,
to make the adjustment. To confirm,
and

Publicidad

Tabla de contenido
loading

Tabla de contenido