Siemens Gigaset SE 105 Guía De Instalación Rápida página 19

Overview of the steps to install a network
1. First install the Ethernet network card or a wireless network adapter such as the
Gigaset USB Adapter 11 or Gigaset PC Card 11 in your PC. The installation procedure
is described in the operating instructions for the product in question.
When installing a wireless network adapter, please note:
i
The factory set SSID of the Gigaset SE105 dsl/cable is
ConnectionPoint.
2. Then install the router.
– Connect the router (see page 20).
– Set up the network (see page 23).
– Configure the router (see page 25).
This will need the access data for your Internet service provider.
These steps are described on the following pages. It will take about 10-15 minutes.
3. If you are using a wireless connection, set up the connection from the wireless
network adapter to the router. This is described in the operating instructions for the
network adapter.
4. You can also connect further PCs and configure them as described on page 28.
Quick Installation Guide
19