Gotec RAPIDO Instrucciones De Servicio Para El Montaje página 16

We advise the use of this contact to cut off refrigeration in the event of an
overflow in the detection unit.
Ensure that the electrical connections to the pump are sealed fully
using the insulating cap, which must be secured with a cable tie.
Hydraulic connection : Hydraulic connection :
Hydraulic connection : Hydraulic connection :
On mini-split, wall mounted equipment, the detection unit is connected to the
end of evacuation pipe by means of a rubber sleeve (supplied). On other types,
the rubber sleeve is connected to the drain tank outlet. The length of this sleeve
can be adjusted. The detection unit must be installed horizontally, in the
location reserved inside the foam elbow (tolerance 15°).To avoid dysfunction of
the magnet, this unit must not be fixed on a metallic brace. Install the
ventilation tube on the detection block.
Ventilation
tubing
The hydraulic discharge connection uses flexible piping having an inside Ø6 mm.
The must not be immersed or placed outside of the premises or in a
RAPIDO
damp place, or in temperature below 0°C.
Tél. +41(0)27 205 7 205 - Fax +41(0)27 205 7 206 - e-mail :
Assembly on the left
Gotec SA, Rue des Casernes 59, CH-1950 Sion –
- 16 -
info@gotec.ch - www.gotec.ch
Tubing
Detection unit