Gotec RAPIDO Instrucciones De Servicio Para El Montaje página 18

Connect the discharge
tube to the pump. The
hydraulic discharge
connection uses
tube having an inside Ø6
mm.
The electric cable must be
attached to the
wrenching support with a
cable tie.
Pre-form the refrigerant
tubes and position them in
the duct. Support
tubes with the mounting
flanges provided.
Before closing the duct, it is advised to support the power cable and the
discharge tube between the insulation of the refrigerant tubes, so that
they do not touch the walls and the lid of the duct. This process will
help decrease the noise level of the installation.
Close the duct and fix the ceiling seal
with one screw (not supplied) or with
the double adhesive face which is on
the ceiling joint.
After testing the pump as described in
chapter 5, close the lid of the hull and
position the duct elbow.
Tél. +41(0)27 205 7 205 - Fax +41(0)27 205 7 206 - e-mail :
flexible
anti-
the
Gotec SA, Rue des Casernes 59, CH-1950 Sion –
Assembly on the left
Assembly on the left
Assembly
on the left
info@gotec.ch
- 18 -
ceiling joint
- www.gotec.ch