BladeLife; BatteryLife; RemovingTheBuilt-InRechargeable; Battery - Panasonic ER‑GS60 Instrucciones De Funcionamiento

Problem
Clipper can be used for
only about 10 minutes
even after charging.
The clipper cannot be
properly cleaned even
after water is poured from
the water inlet.
Makes a loud sound.

Bladelife

Blade life varies according to the frequency and length of use of
the clipper.
For example, the blade life is approximately 2 years when using the
clipper for 20 minutes twice a month. Replace the blades if cutting
efficiency reduces substantially despite proper maintenance.

Batterylife

Battery life will vary according to the frequency and length of use.
If the battery is charged once every 2 weeks, the service life will
be approximately 3 years.
• It is recommended that the clipper be recharged at least every 6
months even when not in regular use because the charge will
drain from the battery and its service life may be shortened.
Action
Contact an authorized service
center for repair.
When the clipper is very dirty,
remove the blade and wash with
water.
Confirm that the blade is properly
attached.
Removingthebuilt-inrechargeablebattery
ATTENTION:
A nickel metal hydride battery that is recyclable powers the
product you have purchased. Please call 1‑800‑8‑BATTERY for
information on how to recycle this battery.
Removethebuilt-inrechargeablebatterybeforedisposingof
theclipper.
This figure must only be used when disposing of the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it will no longer be waterproof, which may cause it to malfunction.
• Remove the clipper from the AC adaptor when removing the

battery.

• Press the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
• Perform steps 1 to 9 and lift the battery, and then remove it.
• Please take care not to short‑circuit the battery.
15