Seams; Condensation (When Using The Privacy Room); Windows; Disassembly - Dometic REVO ZIP 200 Manual De Instalacion Y Uso

200, 240, 270, 310, 350, 400, 450

7.2 Seams

NOTE:
The main seams of this bag awning have been factory taped. It may be necessary to treat the remaining seams with
a seam sealant. Seam sealant should also be applied to areas where the taping is damaged or has peeled away
through wear and tear. It can also be applied to areas where a leak may have developed. Seam sealant is available
through your dealer.
1. Check the seams visually.
2. Reseal damaged and worn seams with seam sealant.

7.3 Condensation (when using the privacy room)

NOTICE!
Prevent condensation!
• Do not use an open flame or cook in the bag awning.
1. Ventilate daily.
2. Lay out a ground cover to prevent condensation.

7.4 Windows

1. Check the windows for dirt accumulation.
2. Remove dirt accumulations from the windows.
8

Disassembly

NOTE:
The bag awning and the panels (optional) must dry completely before storage. If necessary, allow to dry out in a
warm and dry, well-ventilated room.

8.1 Privacy room (optional)

1. Remove the ground cover (if fitted).
2. Remove the curtains.
3. Close all doors and windows.
4. Remove all pegs.
5. Open the velcro straps at the support struts.
6. Unzip the side panels from the front panel.
7. Pull the front panel carefully out of the rail (keder strip).
8. Unzip the side panels.
9. Place the panels on a clean surface if possible (ground cover).
10. Remove any dirt (leaves, grass, e.g.).
11. Fold the panels together.

8.2 Bag awning

1. Remove all pegs.
2. Remove the storm straps.
3. Loosen the roof-side support strut from the holder (fig. 4 1, on page 2).
4. Push the roof-side support struts back using the press release holes and fold them up (fig. 4 2, on page 2).
5. Push the support poles back into the hub and fold them up.
There are two ways to roll up the bag awning.
• The bag awning remains on the motorhome/caravan:
1. Roll the bag awning up into the transport bag (fig. h , on page 4).
2. Secure the bag awning with the quick release fasteners (fig. j , on page 4).
3. Close the zipper of the transport bag.
EN
4445103142
Disassembly
9