Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT
SPECIFICATIONS
MODEL NUMBER
917.37752A
SERIAL
NUMBER
DATE OF PURCHASE
HORSEPOWER:
5.0
DISPLACEMENT:
11.5 CUr IN_
GASOLINE
CAPACITY/'TYPE:
! ,6 QUARTS
UNLEADED
REGULAR
OIL TYPE (API-SF/SGiSH):
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW 32°F)
OIL CAPACITY:
20 OZS.
SPARK PLUG(GAP:
.030")
CHAMPION
RJ19LM OR J19LM
VALVE
CLEARANCE:
INTAKE:
005"
EXHAUST:
.007"
SOLID STATE IGNtTION
AIR GAP:
.010 IN.
BLADE BOLT "TORQUE:
35-40 FT. LBS.
° The model and serial numbers witl be found on a decal attached
to tile rear of the
lawn mower housing. Record both serial number and date of purchase
in space
provided above.
LAWN
MOWER
Always observe safety rules when performing
any maintenance..
TIRES
', Keep tires free of gasoline, oft, or insect
control chemicals which can harm rubber
,, Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
o Remove blade and attaching hardware
(bolt, tock washer and hardened washer).
NOTE:
Remove
the blade adapter
and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly,
Replace
adapter if damaged.
TO REPLACE BLADE
tire damage.
BLADE CARE
For best results, mower blade must be kept
sharp.
Replace bent or damaged blades.
TO REMOVE BI_,DE
,, Disconnecl spark plug wire from spark plug
and place wire where it canflot come in
contact with spark plug
o Turn lawn mower on its side. Make sure air
filter and carburetor are up
,, Use a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt.
o Protect your hands with gloves and/or wrap
blade with heavy cloth.
,, Remove blade bolt by turning counter;
clockwise. Use a 9/I6" box or open.-end
wrench.
• Position the blade adapter on the engine
crankshaft
Be sure key in adapter and
crankshaft keyway are aligned,
• Position blade on the blade adapter aligning
the two (2) holes in the blade with the raised
lugs on the adapter°
o Be sure the trailing edge of blade (opposite
sharp edge) is up toward the engine.
. Install the blade bolt with the lock washer
and hardened washer into blade adapter
and cranksllaft,
,, Use b!ock of wood between blade and lawn
mower housing and tighten the blade bolt,
turning clockwise
. The recommended tightening torque is 35-
40 ft. Ibs.
IMPORTANT:
Blade bolt is grade 8 heat
treated.
1I
Publicidad
Tabla de contenido
