Control Panel Tc - Cuenod C 75 Instrucciones De Montaje

Start up
Functions

Control panel TC

TC
Control panel TC
All control elements can be seen from
the outside.
A transparent removable lid, clipped on
cover, provides access to various
controls and commands that enable to
set, then operate burner.
Control panel TC also includes a cell
current, two green indicators showing
type of fuel used and the control circuit
protective fuse.
To remove lid, press one side or both
sides of s and pull towards you to free
it.
To put lid back, place in casing and
press both clips in.
42
06/2006 - Art. Nr. 13 013 497B
Switch functions on the control panel
(TC)
A2 Standardized 48x48 or 48x96 mm
positions for installation of a power
regulator (option)
B10 Measuring bridge [µA DC]
of cell current, located next to the
motor protection device
F10 Fuse of the control panel (TC)
Green indicators
H1 OIL fuel
H4 GAS fuel
S1 General switch of TC
0 Not supplied with voltage
1 Supplied with voltage
Green indicator H10 illuminated
S2 Choice of power setting
K
Manual mode with S3
Auto Localised mode
S3 Function coupled with
S29J - S2K
+/- Power increase/decrease
S4 Function coupled with
S29J - S2K
Selection of oil fuel or gas fuel
S7 Function coupled with
S29J - S2K
Manual selection of oil stages
S7.1 Min air flow
S7.2 Nominal air flow
S29 Switch of selection of control type
K
Localised mode
H
Remote control mode fuel
change over (option)
SA1 The control unit displays:
- program cycle,
- faults : red light illuminated
and reset pushbutton