External Cleaning; Cleaning The Registers - Bio Bronpi Aire Serie Instrucciones De Instalación, Uso Y Mantenimiento

8.7

EXTERNAL CLEANING

Do not clean the external surface of the stove with water or abrasive products because they may damage the stove. Use a feather duster or
a rag a bit wet.
8.8

CLEANING THE REGISTERS

To keep the validity of the warranty it is mandatory to do the register cleaning by an technician authorised by Bronpi
Calefacción, who will write down the statement made.
It involves cleaning the ashes register of your stove such as smoke zones.
First of all you must clean the whole inside of the combustion chamber, removing the inside plates of the stove because of the soot uses to
accumulate on walls and it difficult the thermal exchange. To do it, you must unscrew the central screw and remove the plates with caution.
Then, brush the surfaces with a wire brush to clean the dirtiness
In models Alba, Kira, Nina, Lola and Sara, to clean the inside of the combustion chamber, please remove the vermiculites inside plates. You
must previously remove the upper baffle-plate, which also Works as a support of the rear vermiculite pieces (see drawing D18). Then, rub
with steel brush the surfaces with deposited dirt.
Mod. Alba, Kira and Nina
It is also necessary to clean the heat exchanger chamber, because of the soot difficult the smoke circulation. To gain access to this zone you
must remove the ceiling of the stove and then do the next operations:
- Remove the cover (baffle-plate) of the top to be able to access to the register. Drawing D19
- Remove the register cover unscrewing the two screws. Drawing D20.
- Clean the ashes deposited on the top. Drawing D21.
- Replace all the pieces and check the staunchness of the register.
NOTE. The models Sara,Lola, Eva, Eva-Nc and Coral do not have this upper cleaning register.
D19
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D18
D20
28
D17
Mod. Lola, Sara, Eva, Eva-Nc and Coral
D21
AIR SERIES