User Mode; Ignition Of The Stove; Stove In Operation; Change Of The Set-Point Room Temperature - Bio Bronpi Aire Serie Instrucciones De Instalación, Uso Y Mantenimiento

Ocultar thumbs Ver también para Aire Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

AUGER SPEED
LOAD
9.5

USER MODE

Below is a description of the display normal operation according to
the available functions.
Before the ignition of the stove, the display shows the following
screen (see drawing D57): It is showed up the "off" state, the room
temperature, the established working power and the current hour.
9.5.1

IGNITION OF THE STOVE

In order to ignite the stove, press button no.4 during a few seconds.
The display will show the ignition state as follows (see drawing D58):
The maximum length of the ignition phase is 20 minutes. After this
time, if there is no visible flame, the stove will automatically go into
the alarm state and the display will show the message "Ignition
Failure."
9.5.2

STOVE IN OPERATION

The hot air fan will start when the smoke temperature reaches a
minimum. Auxiliary fans (in case of models of stoves Lola, Sara,
Clara Extra, Cleo Extra and Olivia Extra) will start only if enabled.
In this moment, the display will show the message "Work." After this,
our stove will be working normally (see drawing D59).
The display shows the ambient temperature in the room.

9.5.3 Change of the set-point room temperature

In order to modify the setting room temperature, please press button
1 and 2 to increase or decrease it respectively (see drawing D60).
9.5.4
ROOM TEMPERATURE REACHES TEMPERATURE
FIXED BY THE USER
When the ambient temperature (of the room) reaches the value set
by the user or the smoke temperature reaches a too high value, the
stove will automatically operate at one lower power; it means that
modulates in power. See drawing D61.
Remember that if it is activated "stand-by mode", when the ambient
temperature reaches the value set by the user plus a differential
(2ºC) the stove will be automatically turned off and will be on hold
until the ambient temperature falls to the set temperature minus a
differential (2ºC). After that, the stove restarts automatically.
9.5.5

BURNER CLEANING

While the stove is working normally, some automatic cleanings of
the burner take place in 30 minutes intervals. This process consists
of cleaning the rest of pellet remaining in the burner in order to
guarantee a proper working of the stove (see drawing D62) and it
takes 30 seconds.
9.5.6

TURNING OFF THE STOVE

In order to turn off the stove, press button no.4 during a few seconds. Once it has been turned off, it will start the final cleaning stage, in
which the pellet supply stops and the smoke extractor will be working
to the maximum speed. This stage would not finish until the stove has
reached the appropriate cooling temperature (see drawing D63).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
POWER
D55
DIALOGUE
36
AL 8
FAILURE
ASPIRATION
D56
STATE
14:24
21 ºC
OFF
14:35
21 ºC
IGNITION
15:18
21 ºC
WORKING
24 ºC
SET TEMP
ROOM
16:40
27 ºC
WORKING
MODULATION
16:40
22 ºC
BURNER
CLEANING
21:10
23 ºC
FINAL
CLEANING
ALARM IN PROCESS
P-2
D57
P-2
D58
P-3
D59
D60
P-2
D61
P-2
D62
P-3
D63
AIR SERIES

Publicidad

Tabla de contenido
loading

Tabla de contenido