Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Alginate mixing:
Press
the main power switch on the
1.
down
reverse side of the machine (Fig. 3). A
LED will light at the left side of the
control panel
.
Press down the power switch located at
2.
the control panel, and make sure that the
indicator of digital display lights on
(Fig. 4).
Prepare the alginate powder following
3.
the instructions of the manufacturer. Stir
the powder and do not compact
Use the bottle to take the required
4.
quantity of water (10-20 ºC). Pour in the
mixing cup with the alginate powder
(follow
the
manufacturer for the proportion)
! IMPORTANT
The hardening time can be controlled by
water
temperature.
summer time, if not use cool water, the
time will be shortened
hardening
The amount of measure cup shall be
5.
calculated as per the correct scale
designated by the supplier of alginate
impression material, please also note
12
Fig. 3
Fig. 4
.
instructions
of
(Fig. 5).
Fig. 5
Particularly
in
that the water amount added will affect
the viscosity of alginate powder.
Fist mix powder and water with the stirrer
6.
for 2 seconds (Fig. 6). You can also just
shake the cup some times. If not, you
could obtain a bad result
before extracting the stirrer, clean it with
Tip:
the cup edge
Close
7.
right (Fig. 7)
Make sure that the small hole at the
8.
center of cap is not obstructed. Follow
the instructions and arrows printed on
the
the lid.
In the meanwhile, m
ready.
Check
impression tray
the
9. Insert the mixing glass into the mixing
wheel. Make sure that it is perfectly
clean and the cup correctly placed inside
(Fig. 9).
.
.
mixing bowl cap turning to the
the
.
ake sure that the unit is
also
the
Fig. 6
Fig. 7
Fig. 8
spatula
and
Publicidad
Tabla de contenido
