Pack Contents; Pre-Installation Info - KS KSL00943 Manual De Instalación Y Mantenimiento

PACK CONTENTS

Familiarize yourself with the part names and confirm that the parts are included.
IP 67 BLACK BATTERy
BOX FOR 6X1.5V AA
TRANSFORMER
ALKALINE BATTERIES
2 screws up to 5mm
(not supplied)
2
9V
1 x Plate with faucet spout,
sensor and solenoid valve

PRE-INSTALLATION INFO

ChECK CONTENTS
Separate all parts from the packaging and check each part with the pack
contents section. Pay attention to the variations of the different models.
Make sure all parts are accounted for before discarding any packaging
material.
If any parts are missing, do not attempt to install your electronic faucet until
you obtain the missing parts.
Min 300 mm.
Bottom of the washbasin
PREPARATION FOR INSTALLATION
Flush the water supply lines thoroughly before installing the faucet. Do not
allow dirt, teflon tape or metal particles to enter the faucet. Shut off the water
supply.
IMPORTANT
All plumbing is to be installed in accordance with applicable codes and
regulations.
Pay attention that the dimensions of the mirror compartment fits the
dimensions of the faucet plate.
wARNINg
1) To avoid reflection problems keep
a distance of more than 300 mm.
between the sink and the spout.
2) This faucet model, with an infra-
red sensor pointing down, is not
intended to be used together with a
sink of a reflective material such as
stainless steel.
3) If a sink strainer is straight below
the faucet sensor, use a strainer with
a non reflective finish (do not use a
chrome plated one).
3