Allmatic KINEO 400 Manual Del Usario página 10

FIXING OF THE REAR PLATE TO THE COLUMN
Fix the rear plate to the column (Fig. 4) in accordance to the desired coordinates.
In case an iron pillar is available, screw directly onto the column the plate with
3 screws M8..
In case you need to fix the bracket onto a concrete pillar, use the fixing plate to
be fastened with 3 Fischer screws of Ø 8 mm.
When the backing plate is fixed, anchor the rear part of the piston to the plate
and fasten it firmly (Fig. 6).
ATTENTION: when establishing the height off the ground at which to fasten
the plate to the pillar (Fig. 4), keep in mind that the plate for anchoring the
piston to the gate must be fastened at the same level (Fig. 5).
FIXING OF THE FRONT PLATE TO THE GATE
For the fixing of the front plate to the leaf, follow this procedure:
1. Fit the anchor plate onto the piston (Fig. 7).
2. Close the gate.
3. Move the piston with the plate already fitted towards the gate.
4. Move the stem to the limit stop, then move it back by approximately 1 cm
and mark the position of the plate.
5. Realize the same operation in opening.
6. If positions correspond, fix the plate on the gate; otherwise revise A and B
coordinates (TABLE 1).
N.B.: during the installation, try several times to open and to close the gate,
controlling that the gearmotor does not touch the moving gate
ADJUSTMENT OF MECHANICAL LIMIT SWITCH - OPTIONAL
The gearmotor may be provided with mechanical limit switches, optional, in
opening and/or closing, if the gate is not fitted with a floor stop (Fig. 8).
To adjust, slacken the screws on the limit switch and move it to the desired
position. Lock the screws (Fig. 9).
MAINTENANCE
To be carried out exclusively by skilled persons after the power supply to
the motor has been interrupted.
Lubricate the hinges and check the thrust force generated by the gearmotor on
the gate once a year.
Lubricate the nut screw with silicone grease every two years.
DISPOSAL OF THE PRODUCT
This product is an integral part of the automation, and therefore, they must be disposed
of together. As for the installation operations, at the end of the life of this product, the
dismantling operations must be performed by qualified personnel. This product is made
from different types of materials: some can be recycled, others must be disposed of. Please
inform yourselves on the recycling or disposal systems provided for by the laws in force in
your area, for this category of product.
CAUTION! – some parts of the product can contain polluting or dangerous substances
which, if dispersed in the environment, may cause serious harm to the environment and
human health.
As indicated by the symbol at the side, it is forbidden to throw this product into
domestic refuse. Therefore, follow the "separated collection" instructions for
disposal, according to the methods provided for by local regulations in force,
or redeliver the product to the retailer at the moment of purchase of a new,
equivalent product.
CAUTION! – the regulations in force at local level may envisage heavy
sanctions in case of abusive disposal of this product.
10/20
FIG. 6
ITA ENG FRA ESP
Front plate
DEU POR
6-1624842
Rear plate
FIG. 4
FIG. 5
FIG. 7
FIG. 8
FIG. 9
rev.6 04/12/2018