Warranty; General Aspects; Special Conditions - CTX PROFESSIONAL E Serie Manual Del Usuario

Low/No chlorine in pool
Clock loses time when
mains power removed

13.0 WARRANTY

1.1

General Aspects

1.1.1 In accordance with these provisions, the seller guarantees that the product corresponding to this Warranty
presents no lack of conformity at the time of delivery.
1.1.2 The Total Warranty period for the product is 2 YEARS, calculated as of delivery to the purchaser. The electrode is
covered by a 2- YEAR WARRANTY (or 4.000 hours), which is not extendable.
1.1.3 If there were any detect in the product and the purchaser informed the seller within the warranty period, the seller
must repair or replace the product at its own cost where it deems fitting, unless this were impossible or
disproportionate.
1.1.4 When the product cannot be repaired or replaced, the purchaser may request a proportional reduction in the
price, or, if the defect is substantial, the termination of the sales agreement.
1.1.5 Parts replaced or repaired pursuant to this warranty will not extend the term of the warranty of the original
Product, while will have its own warranty.
1.1.6 For this warranty to be effective, the purchaser must accredit the date of purchase and delivery of the Product.
1.1.7 When more than six months have elapsed between the delivery of the Product to the purchaser and the latter
alleges a defect, the purchaser must substantiate the source and the existence of the alleged defect.
1.1.8 This Warranty Certificate does not limit or prejudge the rights that correspond to the consumers by virtue of
obligatory national legislation.
1.2

Special Conditions

1.2.1 For this warranty to be effective, the purchaser must strictly follow the Manufacturer's indications included in the
documentation supplied with the Product, when applicable according to the range and model of the Product.
1.2.2 When a programme is specified for the replacement, maintenance or cleaning of certain parts or product
components, the warranty will only be valid when programme has been followed properly.
1.3 Limitations
1.3.1 This Warranty will only be applicable to sales made to consumers, with "consumer" taken to mean any person that
purchases the Product for a purpose outside the sphere of their own professional activity.
1.3.2 No warranty is given regarding normal wear through the use of the product, or with regard to parts, components
and and/or perishable materials or consumables (barring the electrode).
1.3.3 The Warranty does not cover cases in which the Product: (i)) has been unduly handled or used; (ii) has been
inspected, repaired, maintained or handled by an unauthorised person; (iii)) has been repaired or maintained with
non-original parts or (iv) has been installed or started up incorrectly.
1.3.4 When the Product defect is a consequence of an incorrect installation or start-up, this Warranty will only be
effective if the installation or start-up is included in the Product contract of sale and was performed by the seller or
under its responsibility.
1.3.5 Damages or faults of the product due to any of the following causes:

Operation at salinities below 3 g/l of sodium chloride and/or temperatures lower than 15°C (59°F) or higher than
40°C (104°F).

Operation at pH above 7.6.

Use of chemical products not explicitly authorised.

Exposure to corrosive environments and/or temperatures below 0°C (32°F) or above 50°C (125°F).
INST 428 CTX PROFESSIONAL E Series Salt Chlorinator V02.17
Fuse blown
Cables not connected to cell
Timer period too short
Chlorine output level too low
Filter needs backwashing
Ph too high
Pool stabiliser (cyanuric acid) too low
Salt level too low
Battery life expired
Have a service technician replace fuse (3
amp slow blow)
Connect cables
Increase timer period - particularly in
summer
Increase chlorine output
Backwash filter
Balance pH level to 7.4 - 7.6
Increase Stabiliser between 30 and 60 ppm
Increase salt to above 6000 ppm
Call a technician
13