General Overview; Chlorinator Control Installation; Cell Installation - CTX PROFESSIONAL E Serie Manual Del Usuario

84.0 MANUTENÇÃO DO CLORADOR E RESOLUÇÃO DE PROBLEMAS .......................................................... 61
85.0 MANUTENÇÃO DO SEU CLORADOR .....................................................................................................62
86.0 RESOLUÇÃO DE PROBLEMAS ...............................................................................................................62
87.0 GARANTIA ............................................................................................................................................ 63

1.0 GENERAL OVERVIEW

Congratulations! You have purchased an CTX PROFESSIONAL E-SERIES Salt Chlorinator. Please read the instructions
carefully and your purchase will provide you with years of trouble free use.
Your CTX PROFESSIONAL chlorinator works by converting some of the salt (sodium chloride) in your pool into chlorine
which starts to destroy algae and bacteria and sanitises your pool. As part of the process, the chlorine is converted back into
salt and hence salt is not consumed.
Your chlorinator control has many features which ensure simple operation of your chlorinator and Filtration system.
The CTX PROFESSIONAL E-SERIES chlorinator has an internal electronic time clock designed to operate the Filtration
pump up to 2 separate time periods each day. The control has a non-replaceable backup power source which is designed to
maintain timer setting memory in the event of an infrequent and short power interruption.
WARNING
: This appliance is not intended for use by persons including young children or infirm persons with reduced
physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Please ensure that young children are supervised to ensure that they do not play with the pump or chlorinator.
To avoid a safety hazard, the supply cord if damaged, must only be replaced by CTX PROFESSIONAL, or its service agent or
a suitably qualified person.

2.0 CHLORINATOR CONTROL INSTALLATION

The CTX PROFESSIONAL E-SERIES Chlorinator control has a Rating of IP23 enabling it to be installed outdoors.
Regulations require that the control is not allowed to be located within 3.5 metres (10 Feet)of the pool water.
The CTX PROFESSIONAL E-Series Chlorinator Control should be installed in a well ventilated position ideally away from
direct sunlight. Ensure that the unit is not located near pool chemicals(CTX-15,CTX-25 &CTX-35) as fumes may damage
the control.
When installing the control on a post, first attach a flat waterproof panel at least 300mm(12") wide by 500mm long. Make
sure the control is located centrally on the panel and sits flat.
Note: The pump current rating must not exceed 8 amps.

3.0 CELL INSTALLATION

The Chlorinator Cell must be located last in the pipe work just prior to the return to the pool. If valves are installed
between the Chlorinator and the pool outlet, it is essential that they cannot deadhead the pump. If the pressure in the cell
exceeds 350kPa(50 PSI) and/or the water temperature exceeds 40º Celsius (104ºF), the cell may fail.
WARNING
Never install the cell before the pump or heater
:
The Cell MUST be installed with the barrel unions underneath (water connections pointing downwards) and the cell should
be horizontal. 50mm (2") fittings have been provided. Use 50mm (2") high pressure PVC pipe and glue into the 50mm (2")
barrel union tails. Make sure that the 'O-rings are correctly fitted and the unions are tightened firmly.
Direction of flow through the Cell is critical - unit must be plumbed with the water entering the cell at the end closest to
the terminal connections (as indicated by flow direction label mounted on cell)
WARNING: It is essential that pipe work and equipment do not allow gases generated from the cell
to collect and build up.
INST 428 CTX PROFESSIONAL E Series Salt Chlorinator V02.17
Pool
Return
Pipe Centres
108mm (4 ¼")
From
Filter/Pump
4