Important; Dismantling - DV Systems ASD10 Manuel De Uso Y Mantenimiento

TROUBLE
The dryer does not let
compressed air flow
through.

IMPORTANT:

The temperature control probe is extremely delicate. Do not remove the probe from its position. In
case of any kind of problem, please contact your "Service Centre"
Pic.4

4.3 DISMANTLING

In case of necessity, dismantle the machine and the relevant packaging in compliance with the
rules locally in force.
Pay particular attention to the refrigerant, as it contains part of the refrigerating compressor
lubricating oil.
Always contact a waste disposal and recycling facility.
Cod. 710.0138.20.00 Rev1A – 10.2010
POSSIBLE CAUSE AND REMEDY
1. Check if the compressed air inlet/outlet is connected properly.
2. The temperature on the control panel display is lower than the nominal value; call a
refrigeration engineer.
3. Check if the temperature control probe in the evaporator is positioned improperly or
faulty.
4. Check if the connecting tubing are clogged; eventually proceed accordingly.
5. Check if by-pass (if present) is installed properly.
6. Check electronic control board. If the trouble persists, replace it.
ENGLISH
11 - 46