Weber 178733 Manual De Instrucciones página 20

20
mDANGER
Do not use an open flame to check
for gas leaks. Be sure there are no
sparks or open flames in the area
while you check for leaks. Sparks
or open flames will result in a fire or
explosion, which can cause serious
bodily injury or death and damage to
property.
1) Mix soap and water.
2) Turn on the cylinder valve by turning
cylinder valve handwheel counter-
clockwise.
3) Check for leaks by wetting the fitting with
the soap and water solution and watching
for bubbles. If bubbles form, or if a bubble
grows, there is a leak. If there is a leak,
turn off the gas and tighten the fitting.
Turn the gas back on and recheck with
the soap and water solution. If leak does
not stop, Contact the Customer Service
Representative in your area using the
contact information on our web site. Log
onto www.weber.com
barbecue.
4) When leak checking is complete, turn
gas supply OFF at the source and rinse
connections with water. To perform
leak checks: open cylinder valve by
turning the cylinder valve hand-wheel
counterclockwise.
m W ARNING: Do not ignite burners
when leak checking.
Check for leaks by wetting the connections with
the soap and water solution and watching for
bubbles. If bubbles form or if a bubble grows,
there is a leak.
Check:
A) VALVE TO-REGULATOR CONNECTIONS.
m WARNING: If there is a leak at connection
(1) turn OFF the gas. DO NOT OPERATE
THE GRILL. Contact the Customer
Service Representative in your area using
the contact information on our web site.
Log onto www.weber.com
Check:
B) REGULATOR TO PROPANE CYLINDER
CONNECTION.
gas instructions
. Do not use the
®
.
®
(3)
(2)
(A)
(B)