Liveview Web - Morningstar EMC-1 Manual Del Operador

The Device tab in MSView can be used to, "Search
for Connected Devices". The search screen will show
the Morningstar Device, its 8-digit serial no. and the
common IP address of the EMC-1 / Morningstar Device.
The IP address can then be used to view Web pages as
described in Section 3.6.2 below. The unit's default IP
address is 192.168.1.253
3.6.2 LiveView Web Pages
Using a Web browser, the EMC-1 allows access to a
Morningstar Device's LiveView Web pages via two
methods:
1) Enter the Morningstar Device's IP address into the
Address bar e.g. http://192.168.1.186
2) Enter a Morningstar Device's NetBIOS name
[product abbreviation + 8-digit serial no.] into the
Address bar e.g. http://ssmppt15320850
Product NetBIOS Abbreviations:
TriStar MPPT
ProStar MPPT
ProStar (Gen 3)
SunSaver MPPT
TriStar PWM
SunSaver Duo
SureSine
tsmppt
psmppt
pspwm
ssmppt
ts
ssduo
suresine
13
NOTE: Many networks are DHCP-enabled, and the IP address
assignment will change after some period of time. The
NetBIOS address is a static Morningstar Device identifier, and
will always point to the Morningstar Device.
After connection to the LiveView server, the following
Web pages are available for viewing:
LiveView
This is the default Web Page, which displays basic
real-time system data, faults and alarms.
Network
This Web Page shows the Morningstar Device's current
Network settings, and allows the option of changing
COM settings, and port forwarding:
DHCP Primary DNS
IP Address Modbus IP Port 502
Subnet Mask Default Device (MODBUS) ID
Gateway HTTP port 80
Data Log
This Web Page displays the current day, and a certain
period of detailed historical system information,
depending on the number of variables set for logging.
System
The System Web Page is used to update EMC-1
firmware. Connected device firmware cannot be
updated through the System Web Page. The System
Web page also shows specific EMC-1 diagnostic
information.
14