MO-EL LUCCIOLA Instrucciones De Uso página 15

an external device to control ambient temperature.
Avoid exposing skin to the rays of the appliance for distances
less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distanc-
es less than 2.70 m.
All users should be made aware of all aspects of operation
and safety and these instructions should be retained for ref-
erence..
Switch on heater and confirm that emitter is operating. Ensure that
the heater is aiming its warmth into the target area by adjusting heat-
er angles as necessary, loosening the sideward screws (fig. 2-C) and
choosing the proper slot (fig. 2-D) for fixing. Tighten the screws at
the end.
Do not use the heater directly near a bathtub, a shower, a swimming
pool. In unoccupied premises it is recommended that the heating
system is switched off and isolated from the electrical supply.
5. MAINTENANCE
Mo-El Lucciola heaters contain no moving parts and therefore very
little maintenance is required other than to ensure that there is no
excessive build-up of dust/dirt on the reflectors or emitters as this
can cause overheating and premature emitter failure (in case, contact
the Technical Assistance Service).
The accumulation of limestone or incrustations reduces the life and
the efficiency of the lamp; it is suggested therefore to avoid the con-
tinued use in presence of water or salt fog. Eventual leavings of salt
water will have to be removed before the use, after having discon-
nected the appliance, by means of soak in sweet water.
6. EMITTER AND SILICON BUMPERS REPLACEMENT
The emitter lasts for around 5000 hours. When changing the lamp,
also the silicon bumpers connected with the lamp must be substi-
tuted. They should be substituted even before if there are signs of
aging. Due to the special sealing and anti-shock design of the heater,
the emitters are not intended to be user replaceable. Please ensure
that all emitters are replaced via the Mo-El service network.
15