Troubleshooting Guide - Cooper Crouse-Hinds ELPS LIGHT-PAK Manual De Instalación

TROUBLESHOOTING
GUIDE
SYMPTOM
1. LED does not light
2. LED is blinking twice
3. After 72 hours, unit is not fully charged
(LED steady) and lamp heads flash
4. LED is blinking three times
All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable. The accuracy
or completeness thereof are not guaranteed. In accordance with Crouse-Hinds "Terms and Conditions of Sale", and since conditions of use are outside
our control, the purchaser should determine the suitability of the product for his intended use and assumes all risk and liability whatsoever in connection
therewith.
SOLUTION
1a. Verify power to fixture.
1b. Verify LED is fully seated in socket.
1c. Verify bulb is good.
1d. Verify transformer is properly
connected to circuit board.
2. Verify battery is properly connected to
circuit board.
3. Remove leads from pushbutton N/C
contacts and terminate the leads on
the N/O contacts.
4. Verify battery voltage under no load is
13.0V or higher after 72 hour charge.
If less than 13.0V consult factory for
battery replacement. If more than 13
volts, consult factory for complete
interior replacement as transformer
and/or circuit board could be
responsible.
Cooper Industries Inc.
Crouse-Hinds Division
PO Box 4999, Syracuse, New York 13221 • U.S.A.
Copyright © 2012, Cooper Industries, Inc.
IF 1510-A
Revision 3
Revised 09/12
Supercedes 12/10